Categories
Contact Us
ADDRESS:
Hope New District, Mengcun Hui Autonomous County, Cangzhou City, Hebei Province
TEL:
PHONE:
+86-17731769777 / +86-17692762363
E-MAIL:
Japan EN 1092-1 Type 12 Slip-on With HUB
Category:
Product Description
Dimensions of PN 10 Flanges EN 1092-1
NOTE 1: Dimensions N1, N2 and N3 are measured at the intersection of the hub draft angle and the back face of the flange.
NOTE 2: For d1 dimensions see document "Flange facing according to EN 1092-1".
Dimensions in mm
* For flanges type 21 the outside hub diameter approximately corresponds to the outside pipe diameter,
NOTE: The p/t ratings from EN 1092-1 apply only for flange types 05, 11, 12, 13 and 21 having nominal sizes up to and including DN 600. The p/t rating of all other flanges shall be agreed between the manufacturer and the purchaser.
Dimensions of PN 16 Flanges EN 1092-1
NOTE 1: Dimensions N1, N2 and N3 are measured at the intersection of the hub draft angle and the back face of the flange.
NOTE 2: For d1 dimensions see document "Flange facing according to EN 1092-1".
Dimensions in mm
* For flanges type 21 the outside hub diameter approximately corresponds to the outside pipe diameter,
** 8 holes is preferred however 4 holes may be supplied upon special request by the purchaser.
NOTE: The p/t ratings from EN 1092-1 apply only for flange types 05, 11, 12, 13 and 21 having nominal sizes up to and including DN 600. The p/t rating of all other flanges shall be agreed between the manufacturer and the purchaser.
Dimensions of PN 40 Flanges EN 1092-1
NOTE 1: Dimensions N1, N2 and N3 are measured at the intersection of the hub draft angle and the back face of the flange.
NOTE 2: For d1 dimensions see document "Flange facing according to EN 1092-1".
Dimensions in mm
* For flanges type 21 the outside hub diameter approximately corresponds to the outside pipe diameter,
NOTE: The p/t ratings from EN 1092-1 apply only for flange types 05, 11, 12, 13 and 21 having nominal sizes up to and including DN 600. The p/t rating of all other flanges shall be agreed between the manufacturer and the purchaser.
FLANGES according to EN 1092-1
Flange facing dimensions according to EN 1092-1 standard
* For PN 160 flnages form can be only B2, C and D
Package
: next page